rThe Perun MOSFET upgrade kit is one among the littlest MOSFET devices on the market. there’s a specialized, ultra-low resistance transistor utilized in Perun channels that power from the battery on to motor, while the mechanical contacts only need to handle small amounts of current to show the MOSFET on and off. Thus, this greatly extends the service life and lowers overall resistance leading to a more dependable airsoft gun with higher rate of fireside .

The following settings are possible to line any combination on the firing modes under “SEMI” and “AUTO” selector positions independently:

Safe
Semi-automatic
2 to five round burst
Full-automatic
Program all of the settings by using the memorable sequences of fireside selector switching and trigger pulls. this is often used for not only firing modes, but also switching active brake, precocking, and battery protection on / off. Altogether, this enables the user to vary the settings at any moment during a matter of seconds, even under the pressure of enemy fire.

Precocking
Having fast trigger response are often a matter of victory or defeat, especially in CQB situations. With precocking enabled, the piston will remain within the rear position after each shot with spring already compressed. This ensures that next shot are going to be fired immediately after you pull the trigger. Precocking works in semi, burst and full-automatic modes.

Battery Protection Mode
Dedicated to Li-Po batteries. If the battery voltage falls to a dangerously low level, the user are going to be notified by a brief sound signal that’s repeated every 30 seconds. If you are doing not want noise to occur, then you’ll freely switch this from on to off.

Double Shot Mode
Double shot mode allows for double shots within the semi-automatic fire setting. After enabling this mode, if semi-automatic fire is about , shots are going to be fired when the trigger is pressed and again when the trigger is released.

The upgrade kit works easily with any battery from 7V do 17V. The circuit is meant to figure albeit the battery has merely enough power to form the airsoft gun at a really low rate of fireside . It also can be used with most extreme setups, with none limitations of the spring rating. the utmost rate of fireside is 50 RPS.

Electronic Fuse
The fuse is meant to figure with Li-Po batteries to save lots of your airsoft gun and battery just in case of a serious malfunction. it’ll automatically disconnect the battery, if a brief circuit or blocked motor is detected.

Active Brake
The G&G ETU has a lively brake, which is retained in Perun’s upgrade kit. The active brakes allows the motor to prevent after each shot. Active brake are going to be an efficient solution within the event of a double shot problem in airsoft guns with a high rate of fireside . It also can prevent the most spring from being compressed for long periods of your time . for instance , if you’ll fire an attempt with active brake before storing your airsoft gun. Active brake are often switched on or off at any time during a matter of seconds.